PLANET SGSW-24040 - Manual (Page 5)

5
3. Terminal Setup
To configure the system, connect a serial cable to a COM port on a PC or
notebook computer and to serial (console) port of the WGSW / SGSW Managed
Switch. The console port of the Managed Switch is DCE already, so that you can
connect the console port directly through PC without the need of Null Modem.
Note
In the terminal setup steps below, this Manual use WGSW Managed
Switch as the example. However, the steps for SGSW Managed
Switch are similar.
A terminal program is required to make the software connection to the WGSW
/ SGSW Managed Switch. Windows’ Hyper Terminal program may be a good
choice. The Hyper Terminal can be accessed from the Start menu.
1. Click START, then Programs, Accessories and then Hyper Terminal.
2. When the following screen appears, make sure that the COM port should be
configured as:
 Baud : 115200
 Data bits : 8
 Parity : None
 Stop bits : 1
 Flow Control : None