PLANET WGSW-20160HP - Manual (Page 5)

5
3. Terminal Setup
To configure the system, connect a serial cable to a COM port on a PC or notebook
computer and to serial (console) port of the Managed Switch. The console port
of the Managed Switch is DCE already, so that you can connect the console port
directly through PC without the need of Null Modem.
PC / Workstation
with
Terminal emulation software
Serial Port
RS-232
Serial Port
115200,8,n,1
A terminal program is required to make the software connection to the Managed
Switch. Windows’ Hyper Terminal program may be a good choice. The Hyper
Terminal can be accessed from the Start menu.
1. Click START, then Programs, Accessories and then Hyper Terminal.
2. When the following screen appears, make sure that the COM port should be
configured as:
Baud : 115200 z
Data bits : 8 z
Parity : None z
Stop bits : 1 z
Flow Control : None z