PLANET WGSW-28040 - Manual (Page 6)

6
4. Logon to the Console
Once the terminal has connected to the device, power on the WGSW Managed
Switch, the terminal will display that it is running testing procedures.
Then, the following message asks the login username and password. The factory
default username and password as following and the login screen in Figure 4-1
appears.
Username: admin
Password: admin
1. On “Username” & “Password” prompt, enter “admin”.
2. On “WGSW-28040>” prompt, enter “enable”.
3. On “Username” & “Password” prompt, enter “admin”.
Figure 4-1: WGSW Managed Switch Console Login screen
Note
1. For security reason, please change and memorize the new pass-
word after this first setup.
2. Only accept command in lowercase letter under console inter-
face.