PLANET WGSW-48000 - Manual (Page 8)


n Configure IP address
3. On “Switch#” prompt, type “configuration” to enter into global configuration
mode.
4. On “Switch(Config)#” prompt, enter the following command and press
<Enter>. As show in Figure 5-2.
Switch(Config)# network parms 192.168.1.100 255.255.255.0
192.168.1.1
The previous command would apply the follow settings for the Managed Switch.
IP: 192.168.1.100
Subnet Mask: 255.255.255.0
Gateway: 192.168.1.1
Figure 5-2 Set IP address screen
5. Repeat Step 1 to check if the IP address is changed.
6. On “Switch#” prompt, type “Save” to save the current configuration.
If the IP is successfully configured, the Managed Switch will apply the new IP
address setting immediately. You can access the Web interface of WGSW Managed
Switch through the new IP address.
Note
If you do not familiar with console command or the related param-
eter, enter “?” anytime in console to get the help description.