PLANET EPN-103 - Manual (Page 11)

11
3. Hardware Installation
This chapter offers information about installing your ONU. If you are
not familiar with the hardware or software parameters presented here,
please consult your service provider for the values needed.
3.1 Safety Requirement
Make sure the GEPON service is enabled. n
Ensure that the optical fiber is long enough to achieve the desired n
installation place.
Put the ONU on a sturdy table. n
Don't open the device when the ONU is operating. n
Contact your local agent for permission if you want to remove the n
chassis.
Allow about 10 cm of clearance around the ONU chassis for heat n
dissipation.