PLANET POE-152S - Manual (Page 2)

– 5 – – 6 –
Hardware Installation
1. Connect standard UTP cable from “Ethernet+DC” of
POE-152 to “Ethernet+DC” of POE-152S. The POE LED
of POE-152S / POE-152 will remains on.
Switch
POE-152
Gigabit
Wireless AP POE-152S
100 meters
DC DC
Power
Data
Power
Data
PoE
1000Base-T UTP
PoE 1000Base-T UTP with PoE
DC Power Line (DC)
Power Data
Warning
The POE-152S accept IEEE 802.3af device;
other in-line power device cause the POE-152S
malfunction.
2. Connect the UTP cable from “Ethernet” of POE-152S to
the RJ-45 port of remote device.
3. Connect DC plug from “DC OUT” of POE-152S to remote
device.
Caution
Please ensure the output voltage is correct for
remote device. Otherwise, it will damage your
remote device.
4. Power on the remote device and its LED indicator remains
on.
Connect with 802.3af devices
The POE-152S also make non IEEE 802.3af devices with
possibility to connect with IEEE 802.3af in-line power device.
Gigabit 802.3af in-line power Switch
POE-152S
100 meters
Power
Data
PoE
Power Data
Gigabit
Wireless AP
1000Base-T UTP
PoE 1000Base-T UTP with PoE
DC Power Line (DC)
DC
Hint
With IEEE 802.3af standard; the POE-152S also
can co-work with IEEE 802.3af end-span switch
that feeding power over pin 1, 2, and 3, 6.
Customer Support
Browse FAQ resource at the PLANET Web site first to check
if it could solve you issue. Need more support information,
please contact PLANET switch support team.
PLANET online FAQ :
http://www.planet.com.tw/en/support/faq.php?type=2
Switch support team mail address :
[email protected]
Copyright © PLANET Technology Corp. 2010.
Contents subject to revision without prior notice.
PLANET is a registered trademark of PLANET Technology Corp. All other
trademarks belong to their respective owners.