PLANET WNAP-3000PE - Manual (Page 5)


Back Panel
Reset Button
This button has two (2) functions:
Reboot - When pressed and released, the Wireless Access
Point will reboot (restart).
Reset to Factory Defaults - This button can also be used to
clear ALL data and restore ALL settings to the factory default
values.
To Clear All Data and restore the factory default values:
1. Hold the Reset Button until the Status (Red) LED blinks
TWICE, usually more than 5 seconds.
2. Release the Reset Button.
The factory default configuration has now been restored,
and the Access Point is ready for use.
LAN
Use a standard LAN cable (RJ45 connectors) to connect this
port to a 10/100/1000BaseT hub/switch on your LAN.
Power Connect the supplied power adapter (12VDC @1A) here.