PLANET FT-722 - Manual (Page 6)

4
5. Installing the Converter
Please follow these steps to install the converter:
•
Turn off the power of the device/station in a network to
which the FT-722 will be attached
•
Ensure that there is no activity in the network
•
Attach MM fiber cable from the FT-722 to the MM fiber
network. TX, RX must be paired at both ends
•
Attach SM fiber cable from the FT-722 to the SM fiber
network. TX, RX must be paired at both ends.
•
Connect the 5VDC power adapter to the FT-722 and
verify that the Power LED lights up.
•
Turn on the power of the device/station, the LNK /ACT
LEDs should light when all cables are attached.
100Base-FX
Multi-mode
Fiber Network
FT-722
100Base-FX
Single-mode
Fiber Network
100Base-FX
Multi-mode to Single-mode
Note:
n To prevent from optic acceptor malfunction, check the
both end including, connectors, cable type (MM/SM), and
wiring distance before power on the Media Converter.
n DIP-switch LFP is turn on by default, any broken link will
cause the other end link down as well. To diagnose which
end is broken, please turn off the LFP and power off/on the
converter again. Please remains it on in normal operation.