PLANET IGT-1205AT - Manual (Page 25)

25
1
2
Step 5: Lightly pull out the bottom of the DIN-Rail from the track to
remove.
2.2.2 Wall Mount Plate Mounting
To install the Industrial Gigabit Media Converter on the wall, please
follow the instructions described below.
Step 1: Remove the DIN-Rail from the Industrial Gigabit Media
Converter; loose the screws to remove the DIN-Rail.
Step 2: Place the wall mount plate on the rear panel of the Industrial
Gigabit Media Converter.
Step 3: Use the screws to screw the wall mount plate on the
Industrial Gigabit Media Converter.
Step 4: Use the hook holes at the corners of the wall mount plate to
hang the Industrial Gigabit Media Converter on the wall.
Step 5: To remove the wall mount plate, reverse steps above.