PLANET VRT-402N - Manual (Page 3)


1. Before Starting Up
This is a step-by-step instruction on how to start up the VRT-402N and get
connected to the Internet.
1) Setup your network as shown in the setup diagram below.
WAN PWR WAN WAN PWR PWR 1 2 3 4 1 2 3 4 1 2 3 4
Internet
NB PC
ADSL
LAN
Power Adapter
5V 2A
2) Then, you need to setup your LAN PC clients so that it can obtain an IP address
automatically. By default the VRT-402N’s DHCP server is enabled so that you can
obtain an IP address automatically.
Note
Please make sure that the VRT-402N’s DHCP server is the only
DHCP server available on your LAN. If there is another DHCP on
your network, then you’ll need to switch one of the DHCP servers
off.
3) Once your PC has obtained an IP address from your router, enter the default IP
address 192.168.0.1 into your PC’s web browser and press <enter>. That is,
key in http://192.168.0.1 to the browser’s address field.
4) The login screen below will appear. Enter the “User Name” and “Password” and
then click <OK> to login.