PLANET WAP-6100 - Manual (Page 4)


Hardware Installation
Before you proceed with the installation, it is necessary that you have enough
information about the WAP-6100.
1. Locate an optimum location and use the provided metal ring to secure WAP-
6100 to a mast.
2. Using provided CAT5 waterproof cable; connect the waterproof connector port of
the WAP-6100 to the “P+DATA OUT” port of PoE Injector.
3. Using Category 3 or higher UTP or STP cable, connect the “DATA IN” port of PoE
Injector to a 10Mbps or 10/100Mbps Ethernet hub or switch, and connect the
management station to a hub or switch on the same LAN.
4. Connect the power cord to the PoE Injector, and plug it into an AC outlet to
power up the WAP-6100.
Note
ONLY use the power adapter supplied with the device. Otherwise, the product
may be damaged.
OUTDOOR INSTALLATION WARNING
IMPORTANT SAFETY PRECAUTIONS:
LIVES MAY BE AT RISK! Carefully observe these instructions and
any special instructions that are included with the equipment you
are installing.