PLANET WNAP-1110 - Manual (Page 54)

User’s Manual of WNAP-1110
-54-
Choose Press the button of the new device in two minutes, and click Connect.
When pressing and holding the WPS/Reset Button on the AP for more than 5 seconds, you
will reset the AP.
Step 2: Press and hold the WPS Button equipped on the adapter directly for 2 or 3 seconds. Or you can click
the WPS button with the same function in the configuration utility of the adapter.
Step 3: Wait for a while until the next screen appears. Click Finish to complete the WPS configuration.
Step 2 By PIN
If the new device supports Wi-Fi Protected Setup and the PIN method, you can add it to the network by PIN with
the following two methods.
Method One: Enter the PIN of your Wireless adapter into the configuration utility of the AP
Step 1: Keep the default WPS Status as Enabled and click the Add device button in Figure 5-35, then the
following screen will appear.
Figure 5-35 Add a new device
Step 2: Choose Enter the new device's PIN and enter the PIN code of the wireless adapter in the field
behind PIN in the above figure. Then click Connect.
The PIN code of the adapter is always displayed on the WPS configuration screen.