PLANET WNRT-630 - Manual (Page 5)


Hardware Installation
1. Locate an optimum location for the WNRT-630. The best place
for your WNRT-630 is usually at the center of your wireless network,
with line of sight to all of your mobile stations.
2. Adjust the antennas of WNRT-630. Try to adjust them to a posi-
tion that can best cover your wireless network. The antenna’s posi-
tion will enhance the receiving sensitivity.
3. Connect RJ-45 cable to WNRT-630 LAN port. Connect one of the
LAN ports on WNRT-630 to your LAN switch/hub or a computer with
a RJ-45 cable.
4. Connect RJ-45 cable to WNRT-630 WAN port. Connect the
supplied Ethernet cable to xDSL/Cable Modem and the WAN port on
WNRT-630.
5. Plug in power adapter and connect to power source. After
power on, WNRT-630 will start to operate.
Note
ONLY use the 12V 1A power adapter supplied with the
WNRT-630. Otherwise, the product may be damaged.
If you want to reset WNRT-630 to default settings, press
and hold the RESET button over 20 seconds and release.
And then wait for WNRT-630 restart.