PLANET CAM-IVP55 User Manual

Please read before using, Package contents, Overview

Advertising
background image

– 1 –

– 2 –

– 3 –

– 4 –

1. Please read before using

1. Please do not directly touch the sensor element. If neces-

sary, use a soft cloth moistened with alcohol to wipe off
any dust.

2. Please be extra careful not to shake the camera.

3. Please avoid places where there is direct sunlight.

4. When the camera is not in use, keep the lens or the lens

cap attached to protect the sensor.

5. Don’t attempt to service this unit yourself unless you are

authorized to do so. This may exposure you to dangerous
voltage or other hazards. Refer all servicing to qualified
personnel only.

6. Please don’t use the camera under the following abomi-

nable environments. Temperature is lower than -10
degrees Centigrade, or is higher than +50 degrees Centi-
grade.

2. Package Contents

• 1 x CAM-IVP55

• 1 x Quick Installation Guide

• 1 x Wrench

• 4 x Screw

3. Overview

Power Input

Video Output

Connector Definition

Connector

Description

Power Input

Connect to a DC 12V power adapter.

Video Output

BNC connector for analog video output.

4. Product Specification

General
Image pick-up device 1/3” SONY Super HAD (Hi-Res.) CCD

Effective Pixels

NT: 768(H) x 494(V)

PA: 752(H) x 582(V)

Horizontal Resolution

550 TVL

Lens

4.3 mm, F2.0

Min. Illuminator

0.3 Lux / F2.0 ; 0 Lux ( IR on )

Auto Electronic Shutter NTSC: 1/60s~1/100,000s

PAL: 1/50s~1/110,000s

S/N Ratio

More than 48 dB

Gamma Characteristic 0.45
White Balance

Auto

Gain Control

Auto

Flickless Mode

On / Off ( NT:1/100, PA: 1/120 )

Back Light Comp.

On / Off

Synchronous System

Internal

Video Output

Composite 1.0 Vp-p, 75 ohm

View Angle

H: 58.3 Degree V: 45.4 Degree

Back Light Comp.

On / Off

IR LED

24 pieces

IR Wavelength

850 nm

IR Distance

20~25 meters

Vandal Resistant

10 pounds

Water Resistant

IP-66

Environment

Power Requirement

DC 12V

IR on: 400mA max. / IR off: 200mA max.

Dimensions

145 x 110 mm (Φ x H)

Weight

1.03 kg

Operating Temperature -10 ~ 50 Degree C

5. Physical Installation

1. Use the provided wrench to loose the tamper-resistant

housing cover with screws still attached on the cover.

Note

During the installation, please take care and
avoid crash. That may cause people hurt and
this device damage

2. Set the mounting base onto the wall or ceiling and

center it over the mounting hole, using the supplied four
retaining screws to secure the main body.

3. Set proper image by moving the camera module and set

the focus by turning the lens to the left or right direction.

Advertising