PLANET CAM-IVP52V - Manual

Overview
Power Input
Video Output
Connector Definition
Connector Description
Power Input Connect to a DC 12V power adapter.
Video Output BNC connector for analog video output.
Physical Installation
1. Use the provided wrench to loose the tamper-resistant
housing cover with screws still attached on the cover.
Note
During the installation, please take care and
avoid crash. That may cause people hurt and
this device damage
2. Set the mounting base onto the wall or ceiling and
center it over the mounting hole, using the supplied four
retaining screws to secure the main body.
– 3 – – 4 –
– 5 – – 6 –
3. Set proper image by moving the camera module and set
the focus by turning the lens to the left or right direction.
4. When the camera focus adjustment has been completed,
use the provided wrench to fasten the tamper-resistant
housing to the main body.
5. Besides the waterproof connector, when using the side
conduit cabling, it is suggested to cover the cables using
metal covers (to prevent external damage and for water-
proof prevention), and wined the waterproof adhesive
tape onto the metal cover before installation.
6. Connect the video output to the monitor or other video
device through a 75 Ohm type coaxial cable and the DC-
Jack to the power source.
Note
Please make sure the power output voltage is
DC 12V (max. ±10%). We suggest using a DC
12V switching power adapter which can provide
a stable power output.
DIP Switch Setting
• Flickerless Function
Set switch-OFF / F.L. to Flicker to enable flickerless func-
tion, in this mode, the switch-AES/ OFF is auto disabled.
• AGC-Hi/ AGC-Lo Function
Adjust the switch to AGC indicates AGC-Hi and OFF indi-
cates AGC-Low. AGC-Hi mode--The maximum AGC gain is
approximately 26dB. AGC-Lo mode--The maximum AGC
gain is approximately 16dB.
• Auto Iris Function
When using an auto iris lens, the switch-AES/ OFF should
be in the OFF position to disable the AES function. Adjust
VR to the proper level.
• BLC Function
Set switch-OFF / BLC to BLC to enable Back Light
Compensation (BLC) function.