PLANET ICA-108 - Manual (Page 4)


Chapter 2. Physical Installation
1. Connect an Ethernet cable
Connect the LAN cable on the ICA-108/ICA-108W to the network device (hub or
switch).
2. Attach the antenna (ICA-108W only)
Finds antenna in accessory and attaches the antenna to the ICA-108W SMA
connector.
3. Check the LED (Front Panel)
The LED is defined to identify LAN/WLAN connection type. When LAN port is
connected, the LED will be green. For WLAN model, if LAN ported is connected,
the LED will be green; if LAN cable is removed; the ICA-108W will change to
WLAN connection and LED change to orange color.
4. Place the ICA-108/ICA-108W on the table or fix it onto ceiling or wall
Use screws to fix the ICA-108/ICA-108W onto the ceiling or wall. You could also
put the ICA-108/ICA-108W in the table directly.
5. Attach the power supply
Plug in power adapter and connect to power source. After power on, ICA-108/
ICA-108W will start to operate.
Note
Only use the power adapter supplied with ICA-108/ICA-108W.
Otherwise, the product may be damaged