Eclipse - Fujitsu Ten CD8445 - Manual (Page 191)

191
If you have a question:
XVI
Displayed information (for troubleshooting)
The information listed in the chart below is displayed to show the status of
the CD, Memory Stick player, Area Shot function, Sirius Radio and CD
changer. Refer to the chart for the appropriate action.
Information Contents Explanation and remedial action to take
INFO 2 NO DISC LOADED IN
THE MAGAZINE There is no disc in the magazine or player.
Load a disc in the magazine. (Load a
music disc.)
INFO 3 DISCS ARE DIRTY OR
DAMAGED The loaded disc is dirty or upside down.
Check it for proper orientation and verify it
is clean.
INFO 5 CD PLAYER AND CD
CHANGER FAILS
MECHANICALLY • The CD player and CD changer is
inoperative for some reason. Go through
the magazine removal procedure.
• If a magazine fails to eject, have your
dealer fix problem.
INFO 6 WHEN THE CD PLAYER
AND CD CHANGER
INTERNAL
TEMPERATURE IS HIGH
(TO PROTECT PICKUP
UNIT) • The temperature in the CD player and
CD changer is too high for operation.
Wait till it cools down.
• Resume playing after the "High
temperature sensed and CD stopped"
display disappears. If the CD still cannot
play, have your dealer repair it.
INFO 7 AN INTERNAL POWER
SUPPLY FAILURE IS
OCCURRING • Turn the ACC off once before turning it
on once again to resume the operation.
• If this condition persists, please contact
your dealer.
LOAD CD changer is in the process of verifying
the presence of CDs after a magazine has
been inserted into the CD changer.
MSINFO 1 YOU TRIED TO
PLAYBACK,
RECORDING AND
READING DATA WHEN
NO MG MEMORY
STICK OR MEMORY
STICK WAS INSERTED Insert MG Memory Stick or Memory Stick.
MSINFO 2 YOU TRIED TO
PLAYBACK AN
INCORRECTLY
FORMATTED MEMORY
STICK Use the deck to format the Memory Stick.
MSINFO 3 THE WRITE
PROTECTION SWITCH
IS LOCKED. Unlock the write protection switch.
MSINFO 4 THE MEMORY STICK
FULL Delete some of the data from the Memory
Stick before saving.
CD8445.book 191 ページ ２００４年１２月１３日 月曜日 午前１１時３０分