Selecting an an-x – ProSoft Technology AN-X-MOD User Manual
Page 56
![background image](/files/866186/content/doc056.png)
Page
52
AN-X-MOD (Master)
November 2011
Selecting an AN-X
Before you can perform an operation on an AN-X, you must select which
AN-X you want the operation performed on. Choose Utilities/Select An
AN-X
to select a specific AN-X.
From the Adapter list, select the network adapter that connects to the
Ethernet network that contains the AN-X.
In the Ethernet MAC Address field, enter the MAC Address of the AN-X
you wish to select. It can be found on the AN-X label or by using the
Locate All AN-X Modules
command. The format is as shown above, six
pairs of hexadecimal digits separated by hyphens.
In the IP Address field, enter the Ethernet IP address of the AN-X you
wish to select. It can be found using the Locate All AN-X Modules
command. The format is as shown above, four decimal numbers, each in
the range 0 to 255.
Both MAC address and IP address must match the settings on the AN-X
in order for communication to occur.