ProSoft Technology 5201-DFNT-104S - Manual (Page 33)

Configure the Gateway 104S v2 ♦ ProLinx Gateway
Protocol Manual (Firmware v2.xx)
ProSoft Technology, Inc.
Page 33 of 157
March 19, 2010
2.1.13 [C_DC_NA_1 104]
This section defines the double point command database for the server
emulated. This information is sourced from the remote client and is transferred to
the database. You can associate a command with a monitored double point
database value to coordinate the command/monitor operation. You must enter
the correct Monitor Point # and Monitor DB Addr values in the table. If the
Require Select parameter is not set to zero, a select command must be received
before an execute command will be processed.
This section takes the following parameters:
Point #:
DB Address:
Monitor Point #:
Monitor
DB Addr:
Require Select:
Each point is two bits and the DB Address value corresponds to the bit offset in
the gateway memory database. For additional information on how to set these
parameters, see the 104S Tutorial and Reference chapters of this manual.
2.1.14 [C_RC_NA_1 104]
This section defines the step command database for the server emulated. This
information is sourced from the remote client and is transferred to the database.
The control value can be associated with a monitored point as described in the
previous example.
This section takes the following parameters:
Point #:
DB Address:
Monitor Point #:
Monitor
DB Addr:
Each point is one, 8-bit byte and the DB Address value corresponds to the byte
offset in the gateway memory database. For additional information on how to set
these parameters, see the 104S Tutorial and Reference chapters of this manual.