Ricoh Pentax К-1 - Manual (Page 116)

7
Appen
d
ix
114
Error Messages
Error Messages Description
Memory card full
The memory card is full and no more
images can be saved. Insert a new
memory card or delete unwanted files.
No image
There are no images that can be played
back on the memory card.
This image cannot
be displayed
You are trying to play back an image in a
format not supported by this camera. You
may be able to play it back on a computer.
No card in the camera
There is no memory card inserted in the
camera.
Memory card error
The memory card has a problem, and
image capture and playback are
impossible. You may be able to play back
or recover the images on a computer.
Card is not formatted
The memory card you have inserted is
unformatted or has been previously used
on another device and is not compatible
with this camera. Use the card after
formatting it with this camera.
Card is locked
The write-protect switch on the memory
card you have inserted is locked. (p.128)
Cannot use this card
A memory card not compatible with this
camera is inserted.
Wi-Fi connection disabled
The capture mode is changed to C
mode while the wireless LAN function is
enabled.
This image cannot
be magnified
You are trying to magnify an image that
cannot be magnified.
This image is protected
You are trying to delete an image that is
protected. Remove the protection from
the image. (p.103)
Not enough battery
power remaining to
activate Pixel Mapping
These messages appear when you try to
perform Pixel Mapping or Sensor
Cleaning, or to update the firmware if the
battery level is insufficient. Install a fully
charged battery.
Not enough battery
power remaining to
clean sensor
Not enough battery
power remaining to
update the firmware
Unable to update firmware.
There is a problem with the
firmware update file
The firmware cannot be updated. The
update file is damaged. Try downloading
the update file again.
Image folder cannot
be created
The maximum folder number (999) is
being used, and no more images can be
saved. Insert a new memory card or
format the card.
Unable to store image
The image could not be saved because of
a memory card error.
The operation could not be
completed correctly
The operation failed. Try the operation
again.
No more images
can be selected
You are trying to select more than the
maximum number of images for the
following functions.
• Select & Delete
• Image Copy
• RAW Development
• Protect
No image can be processed
There are no images that can be
processed using the Digital Filter or RAW
Development function.
This image cannot
be processed
This message appears when you try to
perform Resize, Cropping, Digital Filter,
Movie Edit, RAW Development, or Save
as Manual WB for images captured with
other cameras, or when you try to perform
Resize or Cropping for minimum file size
images.
This function is not available
in the current mode
You are trying to set a function that is not
available with the currently selected
capture mode.
The camera will turn off
to prevent damage from
overheating
The camera will turn off because its
internal temperature is too high. Leave
the camera turned off until it has had time
to cool down before turning on the
camera again.
Shutter release is disabled.
Ensure the zooming index on
the lens is set to a position
that permits shutter release
Pictures cannot be taken when a
retractable lens is attached and is not
extended. (p.41)
Error Messages Description