Ricoh Pentax К-1 - Manual (Page 47)

3
Shoo
ting
45
1
Set the mode dial to the desired exposure mode.
Q or R appears on the
status screen for the value that
can be changed.
The value that can be changed is
underlined in the viewfinder.
The values of the current camera
settings are displayed on the LCD
panel.
During Live View, D appears for
the value that can be changed.
2
Turn R.
The aperture value is changed in
J
, K, L, M, or N mode.
The sensitivity is changed in H
mode.
3
Turn Q.
The shutter speed is changed in
I
, K, or L mode.
t Memo
• The settings for the exposure can be specified in increments
of 1/3 EV steps. In [1 EV Steps] of the E1 menu, you can
change the adjustment steps to 1/2 EV steps.
• In L or N mode, the difference from the correct exposure is
displayed on the EV bar scale while the exposure is adjusted.
• For each exposure mode, you can set the camera operation
for when Q or R is turned or M is pressed. Set in
[E-Dial Programming] of [Button Customization] in the A5
menu. (p.99)
u Caution
• The correct exposure may not be obtained with the selected
shutter speed and aperture value when the sensitivity is fixed
at a certain sensitivity.
• In M mode, the drive mode cannot be set to [Continuous
Shooting], [Bracketing], or [Interval Shooting].
When shooting with a slow shutter speed, you can reduce
image noise in [Slow Shutter Speed NR] of [Noise Reduction] in
the A2 menu.
1/ 1/ 30 30
100 100
FF 4.5 4.5
99999 99999
99999 99999
1/ 30 1/ 30 F4.5 F4.5 100 100 9999 9999
Noise Reduction when Shooting with a
Slow Shutter Speed
A 2
AUTO
Applies Noise Reduction according to the shutter
speed, sensitivity, and internal temperature of the
camera.
ON
Applies Noise Reduction when the shutter speed is
slower than 1 second.
OFF
Does not apply Noise Reduction at any shutter
speed.