Sharp PN-60TW3 - Manual (Page 32)

32
E
Menu Items
ADVANCED
AUTO (D-SUB1[RGB]/D-SUB2/Direct Drawing/Wireless)
The ANALOG GAIN and ANALOG OFFSET are automatically adjusted.
Pressing
ENTER performs adjustment.
ANALOG GAIN (D-SUB1[RGB]/D-SUB2/Direct Drawing/Wireless)
Adjusts the bright portions of the video input signal.
ANALOG OFFSET (D-SUB1[RGB]/D-SUB2/Direct Drawing/Wireless)
Adjusts the dark portions of the video input signal.
3D-NR (AV input)
Reduce the noise of playback images on video.
Setting a higher level reduces more noise. However, it may cause blurring on an image.
MPEG-NR (AV input)
Reduce block noise caused by digital compression.
3D-Y/C (D-SUB1[VIDEO])
Specify whether to perform 3-dimension Y/C separation.
If dot interference or cross-color is occurring in fast-motion scenes, selecting “OFF” may improve the image quality.
RGB INPUT RANGE (HDMI[PC]/HDMI[AV]/D-SUB1[RGB]/D-SUB2/DisplayPort/Direct Drawing/Wireless)
Sets the RGB input signal range. When using HDMI or DisplayPort set to AUTO, the RGB input signal range is detected
automatically. Use AUTO normally.
If the RGB input signal range cannot be set appropriately even when using AUTO, set according to the image. When the
setting is different, images will be displayed with washed out blacks and compressed gradients.
ACTIVE CONTRAST (AV input)
Automatically adjusts the contrast according to the image.
(In PIP mode, the main side setting is reflected in the image.)
The adjustment operation may not be smooth depending on the image. In this case select OFF.
DISPLAY COLOR PATTERN
Displays a color pattern. Can be displayed while the menu screen is displayed, so you can refer to the pattern while adjusting
the image.
OFF ...............No pattern display.
WHITE ...........White single color pattern display.
RED...............Red single color pattern display.
GREEN .........Green single color pattern display.
BLUE .............Blue single color pattern display.
USER ............Red/green/blue mixed color pattern display. When USER is selected, set each color’s level.
RESET
Resets the values of the PICTURE menu items to the factory preset values.
Select “ON” and then press ENTER .