Epson 4000 - Manual (Page 30)

Starting the SETUP Program
Whenever you start your computer, you see the following
message:
Press <F2> to enter SETUP
If the system detects
an
error in your system configuration, you
will see an error message followed by this message:
Press <F1> to resume, <F2> to Setup
In either case, press F2 to run the SETUP program to verify or
change your configuration.
The SETUP program displays the Main Menu. From this menu,
you can select the various SETUP options to identify your
system’s configuration and then save your new values to
CMOS. If you change your mind, you can ignore any changes
you have made and restore the default values stored in ROM or
load the values previously stored in CMOS.
The table below lists the keys you can use to perform SETUP
operations.
SETUP function keys
Key Function
Move the cursor to the next or previous modifiable option
+ - Change the values in the field
Home End Move the cursor to the top or bottom of the menu
F1 or Alt H Displays a help screen describing the option currently
selected
F 5 o r -
F6 or + or
Space bar
Selects the previous value
Selects the next value
2-2 Running the SETUP Program