Epson 4000 User Manual
Page 93
Advertising
3. Locate one of the power supply cables that lead from the
power supply. (They have multi-colored wires and a plastic
connector on the end.)
4. Align the notched corners of the power supply cable
connector with the notched corners of the drive’s power
supply connector (such as the one shown below). Make
sure the holes fit over all the pins and then push in the
connector.
Caution
If you do not align the cable connectors correctly, you could
severely damage your drive when you push them in.
If you installed a diskette drive in the upper bay, it is drive B;
the lower drive is A. You can change the drive assignments
through your operating system or you can purchase a different
diskette drive ribbon cable.
Installing and Removing Drives
5-17
Advertising