Built-in diagnostics – Dell P2723DE 27" 1440p USB Type-C Hub Monitor User Manual
Page 85
Troubleshooting
│
85
No HDMI Cable
The display will go into Standby mode in 4 minutes.
www.dell.com/P2X23DE
NOTE: The message may be slightly different according to the
connected input signal.
NOTE: While in self-test mode, the power LED remains white.
4.
This box also appears during normal system operation, if the video cable
becomes disconnected or damaged.
5.
Turn Off your monitor and reconnect the video cable; then turn On both your
computer and the monitor.
If your monitor screen remains blank after you use the previous procedure, check
your video controller and computer, because your monitor is functioning properly.
Built-in diagnostics
Your monitor has a built-in diagnostic tool that helps you determine if any screen
abnormality you experience is an inherent problem with your monitor, or with your
computer and video card.
To run the built-in diagnostics:
1.
Ensure that the screen is clean (no dust particles on the surface of the
screen).
2.
Press the Joystick buttton to launch the OSD Menu Launcher and move the
Joystick up to select “
” to open Main Menu.
odes