Lenovo ThinkCentre Tiny-In-One 24 Gen 5 23.8" Multi-Touch Monitor with Webcam - Manual (Page 12)

Setting up your monitor
This section provides information on how to set up your monitor.
Assembling your monitor
To assemble your monitor, follow the two parts below one by one:
Part 1: Install the full-function monitor stand.
Part 2: Install the Tiny.
Part 3: Install the rear Wi-Fi antenna (optional).
Part 4: Install the Kensington-style cable lock (optional).
Part 1: Install the full-function monitor stand.
Note: The full-function monitor stand includes one monitor stand and one stand base.
1. Place a soft, clean towel or cloth on the desk or surface. Hold the sides of your monitor
and gently lay it down so that the screen is against the surface and the cover is facing
up.
2. Insert the three metal studs on the base into the corresponding holes in the stand. Then,
tighten the screw as shown to secure the stand .
3. Insert the two metal tabs on the stand into the corresponding holes on the rear of the
monitor. Then, pivot the stand downward until it clicks into position.
2
1
Part 2: Install the Tiny.
1. Press the decorative cover 1 as shown to remove it. Then, press the button 2 to open the
cable cover.
Note: Keep the decorative cover for future use.
1-7 Flat Panel Monitor User’s Guide