Christie Access Series II UHD752-L 75" UHD 4K Commercial Monitor - Manual (Page 33)

Display panel menu contents
Access II Series LCD Panel User Guide
020-001836-01 Rev.1 (09-2020)
Copyright © 2020 Christie Digital Systems USA, Inc. All rights reserved.
33
Power Up Setting Menu
Power Up Mode Configures the power up mode preference. Last State, Always On and
Standby options are available.
Quick Standy If enabled, the display can be turned on again with the RS232 and
LAN commands if it is turned off through it. Press the left or right
buttons to enable or disable the feature.
Power on Delay Sets a delay value at power on. This value can be set from 0 to 2000 ms
in steps of 100 ms. The Display turns on after the set delay time is
expired.
Auto Launch Configures the auto launch preference. CMS(Start url), Open
Browser(Open Browser initial page), and Disabled options are
available.
Boot Up Picture Mode Configures the picture mode preference at power on. If set as
Off the last set picture mode will be used at power on.
HDMI1 Wake Up
If set as Enabled , the display turns on with the HDMI1 input source,
when it is switched on. This feature works based on the HDMI 5V signal.
When this signal is active, the display wakes up and when the signal is
inactive the Display shuts down. Disable this option by setting as
Disabled . To use this feature in conjunction with the Auto Source Switch
Christie recommends enabling the Auto Source Switch option in the
Signage>Controls menu.
If any Scheduler is set , this option is inactive and cannot be set as
Enabled. and can not be set as Enabled .
Note: This feature may not be available depending on the model
of your unit.
HDMI2, HDMI3, HDMI4
Wake Up (Optional)
If is set as Enabled , the display turns on with the active input source
(HDMI2, HDM3 or HDMI4 depending on which input source is active), when
it is switched on.
Works based on the HDMI 5V signal. When this signal is active the display
wakes up and when the signal is inactive the Display shuts down. You can
disable this option by setting as
Disabled . To use this feature in
conjunction with the Auto Source Switch feature, Christie recommends
enabling
the Auto Source Switch option in the Signage>Controls
menu.
If any Scheduler is set this option is be inactive and can not be set as
Enabled .
Note: This feature or HDMI3 and HDMI4 options may not be
available depending on the model of your unit. If multiple devices are
connected to the display through HDMI input sockets, this feature
does not work.
USB
Clone to USB Copies the database files from the unit to a connected USB device.
Clone From USB Copies the database files from a connected USB device to the unit.
Copy app cache from USB Copies app cache data from a connected USB device to the unit.
Note: This feature may not be available depending on the model of your
unit.
USB Information Press OK to open the USB information menu screen. Current Total
space and Free space information of the connected USB device will be
displayed. You can also format the connected USB device using the
Format Disk option in this menu (FAT32 format only).
USB Operations Highlight and press OK to perform USB operations