Panasonic TH-65CQ2U 65" 4K LED Commercial Display - Manual (Page 23)

23
English
USB terminal connection
Connect a USB memory device to the USB port.
Note
● Do not connect a USB device other than a USB
memory device.
● Turn off the power of the TV when removing a USB
memory device.
● If the power is turned off or the USB memory device
is removed while accessing data in the USB memory
device, the stored data may be destroyed. The
access indicator of the USB memory device blinks
during data access.
■
Supported USB memory device
File System FAT16/32
Capacity Up to 32GB
(maximum file size 4 GB)
Note
● Do not use a USB memory device with a security
function or a write protection function.
● Multi partition is not supported.
● Use a USB memory device with a shape that can
be inserted in the USB port. Some USB memory
devices with special shapes cannot be inserted. Do
not forcibly insert a USB memory device. This may
damage the connector and cause failure.
Pin assignments and signal names for USB Terminal
1 3 4 2
Pin No. Signal name
+5 V DC
DATA -
DATA +
GND (Ground)
Power of up to 5 V / 2.0 A can be supplied to an external
device when the picture is displayed.
Note
● If the direct connection to this unit is not possible due
to the size of a stick PC, etc. use a commercially sold
extension cable.
● Depending on the type of a USB memory device,
it may come in contact with the periphery such as
a back cover, and cannot be attached. Use a USB
memory device connectable to this unit.
● When connecting the USB memory device, confirm
the orientation of the plug to prevent damage to the
terminal.
● When removing the USB memory device, note the
following.
• When the access indicator of the connected USB
memory device is blinking, it shows the TV is
loading the data. Do not remove the USB memory
device while blinking.
• Depending on the USB memory device, the access
indicator may remain blinking even when it is not
being accessed, or the device is not equipped
with an access indicator function, etc. In this case,
remove the USB memory device after confirming
the following or .
Switch the input to an input other than [USB],
and confirm that the functions that access USB
memory device are finished.
Turn the unit off.
• Do not frequently repeat connecting/disconnecting
the USB memory device. Wait at least 5 seconds
after connection, and then remove the USB
memory device. Before reconnection, wait at least
5 seconds. A certain length of time is required so
that the TV can recognise that the USB memory
device is switched for connection or disconnection.
• If the power of this unit is turned off or the USB
memory device is removed accidentally while
accessing data, the data may not be accessed
next time the USB memory device is used.
In such a case, turn the power of the main unit off
and on.