Asus ROG STRIX B650E-E GAMING WIFI AM5 ATX Motherboard - Manual (Page 32)

1-18 Chapter 1: Product Introduction
Chapter 1
15. System Panel header
The System Panel header supports several chassis-mounted functions.
PLED
PLED
SPEAKER
HDD_LED
PWRSW
RESET
PIN 1
PLED+ PLED- PWRBTN# GND +5V Ground Ground Speaker Intruder#
HDD_LED+ HDD_LED-
Ground
RSTCON#
NC
PLED+ PLED-
GND
PANEL
CHASSIS
• System Power LED header (PLED)
The 2-pin and/or 3-1 pin headers allow you to connect the System Power LED. The
System Power LED lights up when the system is connected to a power source, or
when you turn on the system power, and blinks when the system is in sleep mode.
• Storage Device Activity LED header (HDD_LED)
The 2-pin header allows you to connect the Storage Device Activity LED. The Storage
Device Activity LED lights up or blinks when data is read from or written to the storage
device or storage device add-on card.
• System Warning Speaker header (SPEAKER)
The 4-pin header allows you to connect the chassis-mounted system warning
speaker. The speaker allows you to hear system beeps and warnings.
• Power Button/Soft-off Button header (PWRSW)
The 3-1 pin header allows you to connect the system power button. Press the
power button to power up the system, or put the system into sleep or soft-off mode
(depending on the operating system settings).
• Reset button header (RESET)
The 2-pin header allows you to connect the chassis-mounted reset button. Press the
reset button to reboot the system.
• Chassis intrusion header (CHASSIS)
The 2-pin header allows you to connect the chassis-mounted intrusion detection
sensor or switch. The chassis intrusion sensor or switch sends a high-level signal
to the header when a chassis component is removed or replaced, the signal is then
generated as a chassis intrusion event.