Escort 3016B - Manual (Page 50)

6 Triggers
Page 2
6.1. Triggering with analogical channels
After selection of the triggering with analogical channels, the following line on screen will allow
you to set parameters for the triggering start condition. It will depend on the selection of only one
threshold or of several thresholds.
6.1.1. Single threshold
Channel: selection of the channel on which the triggering start threshold is assigned
Threshold 1 / Threshold 2: selection of the threshold to parameter; each channel is tested with
two thresholds. You can, for example, program a start condition on the channel A1 and the
Threshold 1, and a stop condition on the same channel A1 and the Threshold 2.
Front: selection of the active front for the threshold
For example, the condition A1 (s1 ): 0.000 V becomes TRUE when the channel A1 turns
higher than 0V.
Threshold value: value of the selected threshold in percentage and true value (taking into
account the current unit and scale in the configuration of the selected channel)
Fine / Coarse: selection of the fine or coarse setting of the selected threshold