Escort 3016B - Manual (Page 62)

8 Direct mode
Page 4
 Stop: condition for stopping the plotting
- Manual: with the Record key
- Trigger: with an association of the analogical or logical channels
see Chapter 6 Trigger
- Wait for : after a delay or at a precise date and time
- Paper length: after writing a programmed length of paper
 After end of plot: action after the end of the plotting; only possible if the start and stop
triggers are not Manual
- Stop: no action
- Rearm: waiting for the start trigger
- Change Setup.: loading a configuration and waiting for the start trigger
 Save Data: simultaneous saving of the measurements in internal memory or on a file
- No save: no simultaneous saving
- Memory: recording in internal memory
- Acquisition period: sampling speed of the channels
- Blocks: dividing the internal memory into blocks
- File: recording on a file
- File name: place and name of the saving file
- Acquisition period: sampling speed of the channels
See chapter File mode to know the limitations of the file recording
 Trigger: condition for stopping the simultaneous saving in internal memory only
- Direct: the same as for paper printing
- Manual: with the Record key
- Trigger: with an association of the analogical or logical channels
see Chapter Trigger
- Pre-triggering: position of the trigger in the memory (in the block)
 Following: actions after the end of the simultaneous acquisition into the memory
- Save on file: saving the acquisition into a file
- Plot: writing the simultaneous acquisition into the memory
- Rearm.: reloading the writing; waiting for the start condition again
 If a speed before start has been programmed, the paper will be fed at this rate
while waiting the trigger.
 The user can urge the trigger at any time by pressing the "Start/Stop" key again
while waiting for the start
 While plotting, pressing this key will stop the plotting
 In case of power failure while plotting, the recorder will start again in the same
status (waiting or writing)