Epson S1C88650 - Manual (Page 22)

14 EPSON S1C88650 TECHNICAL MANUAL
3 CPU AND BUS CONFIGURATION
3.6.6 Bus authority release state
The S1C88650 is equipped with a bus authority
release function on request from an external device
so that DMA (Direct Memory Access) transfer can
be conducted between external devices. The
internal memory cannot be accessed by this
function.
There are two terminals used for this function: the
________
bus authority release request signal (BREQ) input
terminal and the bus authority release acknowledge
________
signal (BACK) output terminal.
________
The BREQ input terminal is shared with input port
________
terminal K03 and the BACK output terminal with
output port terminal R33, use with setting to
________ ________
BREQ/BACK terminals done in software. In the
single chip mode, or when using a system which
does not require bus authority release, set respec-
tive terminals as input and output ports.
Input
port
K03
Output
port
R33
BREQ
input
BACK
output
_______ _______
Fig. 3.6.6.1 BREQ/BACK terminals
________
When the bus authority release request (BREQ =
LOW) is received from an external device, the
____
S1C88650 switches the address bus, data bus, RD/
_____ ____
WR signal, and CE signal lines to a high impedance
________
state, outputs a LOW level from the BACK terminal
and releases bus authority.
________
As soon as a LOW level is output from the BACK
terminal, the external device can use the external
bus. When DMA is completed, the external device
________
returns the BREQ terminal to HIGH and releases
bus authority.
Figure 3.6.6.2 shows the bus authority release
sequence.
During bus authority release state, internal memory
cannot be accessed from the external device. In
cases where external memory has areas which
overlap areas in internal memory, the external
memory areas can be accessed accordance with the
____
CE signal output by the external device.
Note: Be careful with the system, such that an
external device does not become the bus
master, other than during the bus release
status.
_______
After setting the BREQ terminal to LOW
_______
level, hold the BREQ terminal at LOW level
_______
until the BACK terminal becomes LOW level.
_______
If the BREQ terminal is returned to HIGH
_______
level, before the BACK terminal becomes
LOW level, the shift to the bus authorization
release status will become indefinite.
CLK
A0–A19
D0–D7
WR
RD
BREQ
BACK
Program exection status
LD [HL],[IX]
PC HL
ANY (IX)
Tw2 T4 T1 T2 T3 Tw1 Tw2 T4 Tz1 Tz2 Tz1 Tz2 Tz1 Tz2 Tz1 Tz2 T1 T2 T3
IX
(IX)
Bus authority release status
Program
exection
status
L L L L H
Fig. 3.6.6.2 Bus authority release sequence