NAD Electronics T 758 V3i 7.1-Channel Network A/V Receiver - Manual (Page 7)

ENGLISH
7
10 PHONES
• Accepts stereo headphone using a standard 1/4-inch stereo phone
plug (use a suitable adaptor for headphones equipped with a
smaller plug).
• Plugging in headphones automatically mutes output from the
speakers.
• For headphone listening, the Front speakers must be set to “Large” at
the “Speaker Configuration” of the Speaker Setup item at the Setup
Menu; otherwise headphone bass response will be restricted.
• Plugging in headphones will automatically switch the T 758 to
Stereo, Stereo Downmix or Analog Bypass modes.
11 FRONT INPUT PORTS
• Use these convenience jacks for occasional sources such as any
analog audio or optical digital audio sources.
• If your source has two output jacks indicative of stereo output,
insert both jacks into the T 758’s corresponding Front “L” (item A) and
“R (MONO)” input to achieve stereo output as well.
• On the other hand, if your source has a single audio out jack only or
is marked “Mono output”, plug this into the T 758’s Front “R (MONO)”
input (item B).
• Use the front optical audio input (item C) for optical digital audio
sources.
12 FRONT MP/MIC INPUT
• Connect your Media Player’s standard stereo phone jack to this
input.
IDENTIFICATION OF CONTROLS
FRONT PANEL