BOSS VE-8 Acoustic Singer - Manual (Page 11)

Settings of the Vocal Effects
English
Deutsch
Français
Italiano
Español
Português
Nederlands
11
Sub-Parameter Settings
1 Long-press the button below.
tn (TONE)
Brightness of the
reverb sound
dL (DIRECT LEVEL)
Volume of the
direct mic when the
effect is on
* This is valid only
for HARMONY.
Gd (GENDER)
Negative (–) settings
give the voice a
more masculine
character, while
positive (+) settings
make the voice more
feminine.
* This is valid
only when the
[CORRECT] button
is lit.
Type Parameter Explanation
ELECTRIC Sp (SPEED)
Adjusts the speed of pitch change.
Higher values produce faster pitch
change.
DIST
RADIO
tn (TONE) Brightness of the sound
HARMONY
AC
(ACCURATE)
Raising this value increases the
accuracy with which the pitch of the
harmony matches the original pitch of
the vocal. With the default setting (10),
the harmony will sound at an accurate
pitch, so if the pitch of the original
vocal is not correct, the harmony might
not sound right. If this occurs, lower
this value.
2 Use the [ ? ] [ = ] buttons to select a value.
3 Press the [EXIT] button to exit settings mode.
Vocal Bypass
You can bypass all vocal effects, for example when you’re
talking between songs.
1 Hold down the [HARMONY] pedal for at least two
seconds.
The [HARMONY] pedal blinks and the vocal effects are
bypassed.
2 To turn the bypass off, press any of the pedals.
Using Multiple Effects Simultaneously
You can use up to three effects of the VOCAL section
simultaneously.
HARMONY DIST
RADIO ELECTRIC
* You can select either one of DIST/RADIO.
1 Long-press the [AUTO] button.
Enters the sub-parameter setting mode.
2 Long-press the [MEMORY] button.
Enters the effect ON/OFF setting mode.
You can also enter effect ON/OFF setting mode by long-pressing
the [AUTO] button.
3 Press the [MEMORY] button to select an effect.
Each time you press the button, the setting changes as follows.
h HIGH db DOUBLE
hr HIGHER rA RADIO
hh HIGH & HIGHER dS DIST
L LOW EL ELECTRIC
hL HIGH & LOW
4 Use the [ ? ] [ = ] buttons to set OFF ( 0 ) / ON ( 1 ).
5 Repeat steps 3–4.
6 Press the [AUTO] button to exit settings mode.
* If you want to cancel the settings (and use only one effect),
press the [EXIT] button.
What the HARMONY [LEVEL] knob Controls
If more than one effect is on, the effect
that is controlled by the HARMONY
[LEVEL] knob can be switched by using
the HARMONY [TYPE] knob.