BOSS VE-8 Acoustic Singer - Manual (Page 14)

Advanced Settings
14
Stomp Pedal Setting
For each memory, you can specify which effect turns on/
off when you press a pedal in Manual mode or Stomp
mode (p. 7).
1 Hold down the [MEMORY] button and press the
[CHORUS] pedal.
The [MEMORY] button and [CHORUS] pedal are lit red; the VE-8
is in stomp pedal setting mode.
At the same time, the button of each effect blinks.
2 For the effect that you want to turn on/off using the
stomp pedal, make its button light.
3 Press the [EXIT] button to exit settings mode.
Memory/Stomp mode
4 Save the setting by following “Saving a Memory”
(p. 7) procedure.
EQ/Noise Suppressor Settings
You can adjust the EQ (equalizer) setting as appropriate
for the characteristics of your mic and guitar.
1 Hold down the [EXIT] button and press the [LOOP]
pedal.
The [LOOP] pedal is lit purple; the VE-8 is in EQ setting mode.
2 Use 1 – 8 (See figure below), to set the value.
5 Turn the knob to set the value
5 Press the button and then use the [ ? ][ = ] buttons to set the
value
MID GAIN
GUITAR
INPUT
SENS
NOISE
SUPPRESSOR MID GAIN
HI GAIN HI GAIN LOW GAIN LOW GAIN
1
2
3
4 5
1 6
2
4 5
3
6 7
8 8
Guitar EQ Vocal EQ
LOW CUT
OFF, 8 (80 HZ),
16 (160 Hz)
20 (200 Hz)–
5.0 (5.0k Hz)
0.5–16
MID FREQ
LOW GAIN MID GAIN HI GAIN
0
50
99
1 3 6
2 4 MID Q 5
7 Guitar Input Sensitivity (0–50–99)
8 Noise Suppressor (GUITAR/MIC)
Suppresses the noise and hum (0–50).
3 Press the [EXIT] button to exit settings mode.
Returning the EQ Settings to the Default Values
In EQ setting mode, you can hold down the [MEMORY] button
and press the [EXIT] button to return the EQ settings to the
default values.