BOSS VE-8 Acoustic Singer - Manual (Page 5)

Connections
English
Deutsch
Français
Italiano
Español
Português
Nederlands
5
Output Settings
Here’s how to select the sound that is output from the XLR
and LINE jacks. With the default settings, the vocal and
guitar sounds are mixed, but you can change the setting
so that the vocal and guitar are output from separate
jacks.
1 Hold down the [MEMORY] button and press the
[LOOP] pedal.
The [MEMORY] button and [LOOP] pedal are lit red; the VE-8 is in
output setting mode.
2 Press the [MEMORY] button to select a parameter
(jack).
Each time you press the button, the setting changes as follows.
“
XL ” ( XLR jacks ) 0 “ Li ” ( LINE jacks ) 0 “ AU ” ( AUX jack ) 0
“ Ph ” ( PHONES jack ) 0 “ US ” ( USB )
MEMO
To return to the previous parameter, hold down the [EXIT]
button and press the [MEMORY] button.
3 Use the [ ? ] [ = ] buttons to select a value.
Parameter Value Explanation
XL (XLR jacks)
Li (LINE jacks)
Selects the sound that is output from the XLR
and LINE jacks.
1 Vocal + Guitar (stereo) (default)
2 Vocal (stereo)
3 Guitar (stereo)
4 L: Guitar (mono) R: Vocal (mono)
5 L: Vocal (effect) R: Vocal (dry)
6 L: Guitar (effect) R: Guitar (dry)
7 Vocal+Guitar (mono)
8 Vocal (mono)
9 Guitar (mono)
AU
(AUX jack)
Selects the output destination of the sound
that is input from the AUX jack.
1 ALL (all jacks) (default)
2 LINE + PHONES jacks
3 PHONES jack
Ph
(PHONES jack)
Sets the volume of the PHONES jack.
0 – 99 (default: 50 )
US
(USB direct out)
Switches the output of the VE-8 sound to the
XLR and LINE jacks.
& For details on the USB, refer to “About USB”
(p. 6).
0
The sound of the VE-8 is not output from
the XLR and LINE jacks; it is output only
to the computer (USB).
Use this when you want to use your DAW
to apply a plug-in effect to the sound of
the VE-8, and output the result from the
output jacks.
1
The sound of the VE-8 is output to the
XLR and LINE jacks (default).
If You Don’t Want to Send Reverb to the PA
When “ XL ” ( XLR jacks ) or “ Li ” ( LINE jacks ) is selected, and
you press the guitar and vocal [LOOP] buttons to make them
blink, reverb is not output from the XLR or LINE jacks. Use this
setting in a situation where you want to use the reverb of the
PA system in a live performance.
4 Press the [EXIT] button to exit settings mode.