BOSS VE-8 Acoustic Singer - Manual (Page 9)

Settings of the Guitar Effects
English
Deutsch
Français
Italiano
Español
Português
Nederlands
9
Sub-Parameter Settings
1 Long-press the button below.
tn (TONE)
Brightness of the
reverb sound
dt (DELAY TIME)
Delay time when
using the delay
(see below)
Eq (EQ)
Equalizer of the
acoustic resonance
Type Parameter Explanation
CHORUS/
TREMOLO/
PHASER
rt
(RATE)
Sets the speed of the effect.
DELAY/
MOD DELAY
Fb
(FEEDBACK)
Sets the number of repetitions for the
delay.
OCTAVE
Vo
(VOICE)
Specifies how the effect sound is layered.
-1 (1 octave below)
1 (1 octave above)
1d (1 octave above + detune)
SLOW GEAR
At
(ATTACK)
Adjusts the time needed for the volume
to reach its maximum.
RING MOD bl
(BALANCE)
Adjusts the balance between the direct
sound and the effect sound.
2 Use the [ ? ] [ = ] buttons to select a value.
3 Press the [EXIT] button to exit settings mode.
Delay Time Settings (Tap Tempo)
By tapping the button or external footswitch in time with
the tempo of the song, you can set delay time of dotted
eighth note or quarter note of the tempo of the song.
& When using the external footswitch to tap tempo, set the
“External Footswitch Setting” (p. 13) to the following value.
Parameter Value Explanation
C1 , C2 14 TAP TEMPO
1 Press the CHORUS [TYPE] button to select “ dL ”
(DELAY) or “ Md ” (MOD DELAY).
2 Long-press the [PHASE] button.
3 Press the [MEMORY] button to select a parameter
(refer to table).
4 Use the [ ? ] [ = ] buttons to select a value.
Parameter Value Explanation
dt (DELAY
TIME)
Sets the delay time ( 1 0– 99 0 ms).
You can also set the delay time by tapping the
[PHASE] button at least twice in time with the
song’s tempo. (Tap Tempo)
* BPM is not displayed.
nt (NOTE)
Sets the note for the delay sound.
d
¸
(Quarter note)
d.&
˚
(Dotted eighth note)
5 Press the [EXIT] button to exit settings mode.
Using Multiple Effects Simultaneously
You can use up to three effects of the CHORUS section
simultaneously.
OCTAVE
SLOW GEAR
RING MOD CHORUS
TREMOLO
PHASER DELAY
MOD DELAY
* You can select one from each group.
1 Long-press the CHORUS [TYPE] button.
Enters the sub-parameter setting mode.
2 Long-press the [MEMORY] button.
Enters the effect ON/OFF setting mode.
MEMO
You can also enter effect ON/OFF setting mode by long-
pressing the CHORUS [TYPE] button.
3 Press the [MEMORY] button to select an effect.
Each time you press the button, the setting changes as follows.
Ch CHORUS md MOD DELAY
tr TREMOLO oC OCTAVE
Ph PHASER SG SLOW GEAR
dL DELAY rM RING MOD
4 Use the [ ? ] [ = ] buttons to set OFF ( 0 ) / ON ( 1 ).
5 Repeat steps 3–4.
6 Press the CHORUS [TYPE] button to exit settings
mode.
* If you want to cancel the settings (and use only one effect),
press the [EXIT] button.
What the [CHORUS] Knob Controls
If more than one effect is on, the effect that
is controlled by the [CHORUS] knob can be
switched by pressing the CHORUS [TYPE]
button.