RIX LEAP L3 3.2-9.6x Thermal Imaging Riflescope - Manual (Page 20)

The battery is out of charge.
The Wi-Fi password is incorrect.
Enter the correct password or reset the
device back to factory setting.
The device cannot be powered by
an external power supply
The image quality is poor or
the detection range shortens.
The device cannot connect to
a mobile phone or computer.
When the device is used at a low
temperature, the imaging quality is
poorer than that at a normal
temperature.
These problems are likely to oc
18 ▶
cur when you use the device in harsh weather
(such as snow, rain, and fog).
There are too many Wi-Fi networks in the
range of the device, which may cause interference.
The device is beyond Wi-Fi coverage.
There is blocking (such as concrete walls)
between the device and the receiver.
Move the device to a place
where you can receive Wi-Fi signals.
At temperatures above 0°C, the temperature rise varies with the observed objects (environ-
ment and background) due to different heat conductivity coefficients. As a result, high-tem-
perature contrast occurs and the image quality is better.
At low temperatures, the observed targets (background) usually cool down to a similar
temperature because of reduced temperature contrast. Therefore, the image quality (details
in particular) is poor, which is a characteristic of thermal imaging devices.
The screen is not bright enough.
Possible Causes Fault
The scope cannot be started.
The image is too dark.
Wi-Fi signals are lost or interrupted.
Solutions
Charging
Adjust the display brightness
The USB cable is damaged.
The external power supply is insufficient.
Replace the USB cable.
If necessary, check the external power supply.
For a stable network connection, it is
recommended to relocate the device toan
area with a lower number of Wi-Fi networks.