Epson Progression U12 - Manual (Page 162)

Accessing Your System
If you have forgotten your current password, follow these steps
to access your system:
1.
2.
Turn off the computer.
Follow the instructions under “Jumper Settings” in Chapter 3
to disable the password function by setting jumper JP6 to
position A.
3.
4.
5.
Turn on the computer.
When you see Press <F2> to run SETUP, press
You see the SETUP screen. If you do not want to set a new
password, go to step 7. If you want to set a new password,
go to step 6.
6. To set a new password, highlight Password and press
Then press Type a new password at the prompt and
press You must enter the new password twice. (See
Chapter 2 of the Setup Guide for more information about
setting a password.) Now go to step 8.
7. To disable password checking, highlight Password
security and press Then press or to
change the setting to Not installed. (See Chapter 2 of
the Setup Guide for more information.)
8. Save your settings as you exit SETUP. (See Chapter 2 of the
Setup Guide for instructions.)
9. Turn off the computer.
10. Follow the instructions under “Jumper Settings” in
Chapter 3 to enable the password function by setting
jumper JP6 to position B.
7-10 Troubleshooting