Epson Progression U12 - Manual (Page 68)

6. Now you need to connect the drive and power supply cables
to the backs of all your drives. See “Connecting the Cables”
on page 4-9 for instructions. (If you also need to connect the
diskette and/or hard disk drive cables to the main system
board, follow steps 4 through 6 on pages 4-21 through 4-23.)
Replacing the Front Panel
Follow these steps to replace the computer’s front panel:
1. Turn the computer so you are facing the front.
2. Align the openings in the front panel with the power and
RESET
buttons, and any drives that extend out from the
front of the computer case. Also align the front panel tabs
with the corresponding notches in the case. Then guide the
front panel straight onto the case, as shown below.
3. Press the front panel onto the computer to fully insert all the
tabs into the notches. If all the front panel tabs do not click
into position, remove the front panel and try again.
Accessing Internal Components 2-11