Epson Progression U12 - Manual (Page 90)

Follow these steps to install the CPU card in your computer:
1. Position the card as shown below, aligning the two connectors
on the bottom of the card with the two slots in the socket on
the main system board. The hole in the bottom of the
bracket should fit over the vertical post on the bottom of the
computer case.
2. Guide the card straight into the socket until it is firmly seated.
If it does not go in smoothly, pull it out and try again.
3. Secure the bracket at the end of the card to the front of the
computer case with the retaining screw.
4. After you replace the computer’s cover, run the SETUP
program so your computer can update its configuration.
See Chapter 2 of the Setup Guide for instructions. (You need
only run the program and save the configuration; you do
not need to change any settings.)
Installing and Removing Options 3-21