Epson Progression U12 - Manual (Page 147)

Modifying the Defective Tack Table
If you select
Y
to modify the table, you see the following
options at the bottom of the table:
Defective
Track Table : Move box cursor to
desired track with cursor key
A Add track, C
I
Change track,
D = Delete
track, F
= Finish
editing
Enter command :
To add a bad track, follow these steps:
1. Press You see this prompt:
Enter cylinder number (1 -
2. Type the number of the cylinder containing the bad track and
press [You see this prompt:
Enter
head number (0 - nn):
3. Type the head number for the bad track and press I. (To
cancel the operation, press IEnbr) without typing a value.)
When you complete a valid entry, it appears in the table and
you can add the next bad track, if necessary.
If you make a mistake, move the cursor block to the incorrect
track and press [cl to change the track data or to delete the
track from the table. Change the track data in the same way as
you add a track.
The maximum valid cylinder number and head number (nnnn
and vary according to the capacity of the hard disk. If you
enter an invalid cylinder or head number, a reminder of the
range of values appears and the program asks you to enter the
value again.
Formatting a Hard Disk 6-7