Epson Progression U12 - Manual (Page 53)

Entering the ESPEED c o m m a n d in a butch file
You may want to run the ESPEED program by including the
command in a batch file. For example, let’s say you have a
program called SLOWDOWN which requires a slower
processor speed. You could include the following commands in
a batch file to start the SLOWDOWN program:
You could name the batch file SLOW.BAT. Whenever you need
to run the SLOWDOWN program, type SLOW and press
The computer changes the processor speed to automatic and
starts the program.
Changing the Speaker Volume
Your computer contains a built-in speaker that beeps when you
perform certain operations. You can control the operation and
volume of this speaker using the SETUP program and the
SETVOL utility, described below.
To enable or disable your speaker, run the SETUP program and
change the setting of the Speaker option, as described in
Chapter 2 of the Setup Guide. (The default setting of the
Speaker option is Enabled.)
If your speaker is enabled, you can run the SETVOL utility
to adjust the volume of the speaker as desired. The file
SETVOL.EXE is on the Reference diskette. You may want to
copy it to your hard disk for convenience.
1-34 Using Your Computer