Epson 8100i - Manual (Page 25)

Setting Up the Projector 19
2. To use the remote control as a wireless mouse, connect the PS/2
mouse or USB cable included with the projector to the MOUSE
terminal on the square end of the main cable.
3. Disconnect your mouse from the mouse port on the back of your
computer and replace it with the other end of the PS/2 mouse or
USB cable. (Your computer’s mouse will be disabled while you are
using the remote control as a mouse.)
4. To use the EMP Link V software or to program new effects for
the Effects buttons on the remote control, connect one end of the
serial cable to the
SERIAL terminal on the main cable.
Connect the other end of the serial cable to the serial port on the
back of your computer.
5. Tighten the screws on the connectors.
note
If your system uses a serial
mouse, perform steps 2 and 3
using the PC serial mouse
cable instead of the PS/2
mouse or USB cable.
note
You won’t be able to use
EMP Link V if your
computer has only one serial
port that is being used to
support a serial mouse.