Epson 8100i - Manual (Page 80)

74 Fine-tuning the Projector
Assigning the Image to the No-Signal Message
and/or A/V Mute Button
After your image is saved, you can set it up as the no-signal message
and/or the screen that’s displayed when you press the
A/V Mute
button.
1. Press the Menu button on the control panel or remote control to
display the Main menu (if not already displayed).
2. Select the Setting menu and then press the Enter button on the
control panel or remote control.
3. Press the down arrow (control panel) or press down on the Enter
button (remote control) to highlight No-Signal Msg .
4. Press the right arrow or use the Enter button to select Logo . This
sets your image as the screen displayed when the projector is not
receiving a signal.
5. If you want to set up your image as the A/V mute, use the down
arrow or Enter button to move down to the A/V Mute option
and select Logo .
6. Press Esc or the Menu button.
Now you can press the A/V Mute button on the control panel or the
remote control to display the user logo or image. Press it again to turn
off the logo.