Epson 8100i - Manual (Page 43)

Setting Up the Projector 37
Connecting S-Video or Component Video
Before starting, make sure the projector and your VCR or other video
source are turned off.
1. For S-Video, insert one end of an S-Video cable into the
projector’s S-Video connector. Insert the other end into the
S-video-out port of your video source.
For component video, connect the three ends of a BNC cable into
the projector’s
R, G, and B ports. (Don’t connect the cables to
the projector’s H/C Sync or VSync ports.) Insert the opposite
ends of the cable into the corresponding ports of your video
source. If the image doesn’t display properly, you may need to
change the BNC parameter in the projector’s Setting menu
(see page 69).
2. If you’ll be using audio, connect the RCA audio cable to the
S-Audio and Audio2 ports of the projector. Connect the plugs at
the other end of the cable to the audio output ports of the video
source.
S-Video
connector
S-Video cable
note
Contact your video
manufacturer or other video
or electronics dealer to obtain
a component video cable.