Epson 8100i - Manual (Page 36)

30 Setting Up the Projector
3. Connect the other end of the cable to the video-out port or
monitor port on your PowerBook. If you can’t connect the cable
to your PowerBook, you may need to use the Macintosh desktop
adapter that came with your projector.
To use the adapter, remove its cover as
shown and set its DIP switches according
to the resolution you want to use, such as
16-inch mode. See your Macintosh
documentation for instructions.
Replace the cover and connect the
adapter to the free end of the computer
video cable. Then plug the cable (with
the adapter) into the video port on your
Macintosh.
If your PowerBook requires a video-out cable, connect its larger
end to the adapter, as shown below. Then plug the video-out
cable into the video port on your Macintosh.
4. Tighten the screws on the connectors.
If you don’t need to make any other connections, you can plug in
your projector and turn it on. See page 40 for instructions.
video out cable
Macintosh desktop adapter
note
After turning on the projector
and computer, you’ll need to
choose Mirroring or Arrange
in the Display Control Panel
if you want the PowerBook
(as well as the projector) to
display
video. See page 42 for
instructions.