HP 2250 - Manual (Page 20)

2-12
Installing Additional Memory
If your printer has the HP PS/PCL5 Kit upgrade installed, you may install
up to 64 MB of additional memory which is available for purchase as an
accessory (part number F1457B).
Note: The HP PS/PCL5 Kit upgrade comes with the HP Business Inkjet 2250
printer. It can also be purchased as an accessory (part number C5935A/C5935C). The
module can be installed in the EIO slot on either side of the printer.
1. Put on an anti-static wrist strap and clip the other end to a grounded
metal piece.
2. Switch OFF your printer and remove all cables from the printer.
3. Loosen the two screws on either side of the printer to remove the
HP PS/PCL5 Kit upgrade (the module can be installed in either side
of the printer).
4. Insert the SIMM into the slot.
5. Replace the module and fasten the screws.
6. Reconnect all cables to the printer and power ON the printer.
For information on ordering memory, see HP Supplies and Accessories.