Heat & Glo Fireplace Heat & Glo Gas Fireplace ESC-42ST - Manual (Page 35)

Heat & Glo • ESC-42ST • 2146-900 Rev. Q • 4/13 35
B. Securing and Leveling the Appliance
WARNING! Risk of Fire! Prevent contact with:
• Sagging or loose insulation
• Insulation backing or plastic
• Framing and other combustible materials
Block openings into the chase to prevent entry of blown-
in insulation. Make sure insulation and other materials
are secured.
DO NOT notch the framing around the appliance
standoffs.
Failure to maintain air space clearance may cause
overheating and fi re.
The diagram shows how to properly position and secure
the appliance (see Figure 9.8). Nailing tabs are provided
to secure the appliance to the framing members.
• Bend out nailing tabs on each side.
• Place the appliance into position.
• Keep nailing tabs fl ush with the framing.
• Level the appliance from side to side and front to back.
• Shim the appliance as necessary. It is acceptable to use
wood shims underneath the appliance.
• Secure the appliance to the framing by using nails or
screws through the nailing tabs.
• Secure the appliance to the fl oor by inserting two screws
through the pilot holes at the bottom of the appliance.
Figure 9.8 Proper positioning, leveling and securing of an
appliance
LOG PACKAGING LOG PACKAGING
MESH ASSEMBLY MESH ASSEMBLY
REFRACTORY ASSEMBLY REFRACTORY ASSEMBLY
EMBER GLASS ROCK (TECO-SIL) EMBER GLASS ROCK (TECO-SIL)
MANUAL BAG ASSEMBLY MANUAL BAG ASSEMBLY
Figure 9.6 Appliance Package Identifi cation.
Figure 9.7 Attaching Non-Combustible Board
FINISHING STRIPS
NON-COMBUSTIBLE
BOARD
Attach the non-combustible board to the appliance and
wall framing with the screws supplied in the manual bag
assembly. See Figure 9.7