Husqvarna 230 ACX - Manual (Page 15)

16 - English
2. PRESENTATION
Search method 3: Follow guide wire
Automower™ runs irregularly until it reaches the
guide wire. The mower then follows the guide wire in
to the charging station.
The guide wire is an extra wire that is laid from the
charging station, out towards a remote part of the
working area or through a narrow passage and is
then connected to the boundary wire. Up to two guide
wires can be installed for 230 ACX. For more
information, see 3.8 Installation of the guide wire on
page 32.
This search method is best for an installation that has
numerous or large islands, narrow passages or steep
slopes.
The advantage of this search method is that the search
times are generally short.
The disadvantage is that the mower can leave tracks in
the grass along the length of the guide wire.
2.4 More than one Automower™ in
a garden
If you install more than one Automower™ in the same
area of lawn, each mower must have its own PIN code.
A complete installation, including charging station, is
required for each mower. The boundary wires for the
different installations can be routed next to each other.
Contact your dealer for further information.
2.5 One Automower™ in several
gardens
One Automower™ can easily be used for more than
one garden, where each garden has its own charging
station and boundary wire. The mower can then have
the same PIN code for all gardens.
Contact your dealer for further information.